User Manual Q&AAnswer
Apr 03, 2025 - 03:07 AM
To set up the BRESSER 9070300 Wireless Weatherstation Transparent, follow these steps:
1. Place the base unit (receiver) and the remote sensor (transmitter) as close together as possible.
2. Connect the power supply to the base unit and wait until the indoor temperature is displayed.
3. Install the batteries in the base station and remote sensor, ensuring correct polarity.
4. Set the desired transmission channel on the remote sensor by pressing the CH button and selecting CH1, CH2, or CH3 on the screen display.
5. Set the desired temperature format (°C or °F) on the remote sensor by pressing the °C/°F button.
6. Wait for the base station to receive the measurements from the remote sensor, which should be displayed within 3 minutes.
7. If the base station does not receive the measurements automatically, press the UP button for approximately 2 seconds to initiate the reception of the radio signal again.
8. If the time is not automatically set by the radio signal, you can set it manually by pressing and holding the SET button for approximately 2 seconds. Use the UP and DOWN buttons to change the values and press SET to confirm and move to the next setting.
9. You can also set the alarm time, snooze function, and temperature alarm by following the instructions in the manual.
10. If you want to connect additional remote sensors, repeat step 4 for each sensor and use the CH button on the base station to display the measurements of different channels.
Please refer to the BRESSER 9070300 Wireless Weatherstation Transparent Instruction Manual for more detailed instructions and illustrations.
Add New Comment