User Manual Q&AAnswer
Apr 03, 2025 - 01:37 AM
To clean the brushroll of the Shark WD100C Series Corded 3-in-1 Cleaner, follow these steps:
1. Turn off the power and unplug the cleaner.
2. Press the button on the top of the nozzle and lift off the brushroll cover.
3. Pull up on the pull tab on the left side of the nozzle to remove the brushroll.
4. Wipe away any debris stuck on the back wall of the nozzle.
5. Wash the brushroll thoroughly with warm water. Do not place it in a washing machine or dishwasher.
6. Allow the brushroll to air-dry completely in a well-ventilated area for at least 24 hours.
7. Reinsert the brushroll by lining up the grooves on the end of the brushroll with the helix on the inner right side of the nozzle. Press down on the left side of the brushroll until it is properly installed.
8. To reinstall the brushroll cover, insert the tabs on the cover into the slots on the nozzle. Press down on the cover until it clicks into place.
Note: It is recommended to replace the brushroll after 6 months of use.
Add New Comment