User Manual Q&AAnswer
Apr 03, 2025 - 01:22 AM
To mount the Optoma ST01 Mobile Trolley on the wall, follow these steps:
1. Install the dual mounting brackets on the rear of the IFP (Interactive Flat Panel). Secure the brackets with four screws (A).
2. Drill eight small holes on the mounting location and insert the anchors into the holes.
3. Position the wall mount on the wall and secure it with eight screws (B) through the washers into the installed anchors on the wall.
4. Align and hook the dual mounting brackets to the wall mount.
5. Secure the dual mounting brackets and the wall mount with two screws (C).
Please note the following:
- The maximum wall mount kit load capacity is 160kg (352lbs).
- Ensure that the wall mount is installed on a wall that can bear the weight of the IFP. If a suitable wall is not available, it is recommended to use a stand instead.
- Screws must be tightly secured, but avoid overtightening to prevent damage to the mounting brackets, wall mount, or IFP.
- The installation should only be performed by qualified technicians to avoid any potential risks or malfunctions.
For more detailed instructions and illustrations, please refer to page 5 of the Optoma ST01 Mobile Trolley User Guide.
Add New Comment