Answer

Mar 29, 2025 - 01:05 PM
To adjust the output voltage on the Velleman LABPS5005 Lab Power Supply, follow these steps:
1. Switch on the device.
2. Turn the current adjustment xxxx fully clockwise to the maximum.
3. Turn the voltage adjustment xxxx to obtain a voltage that is close to the desired value. Use the fine-tune xxxx if applicable. The constant voltage (C.V.) indicator will light up on the display.
To adjust the output current on the Velleman LABPS5005 Lab Power Supply, follow these steps:
1. Switch on the device.
2. Turn both the current adjustment knobs fully anticlockwise to the minimum and the voltage adjustment knobs fully clockwise to the maximum.
3. Short-circuit the output terminals by interconnecting them with the appropriate cable (60 V/16 A DC cable).
4. Turn the current adjustment xxxx to the required current-limiting value. Use the fine-tune xxxx if applicable. The constant current (C.C.) indicator will light up on the display.
5. Remove the short-circuit cable from both output terminals.
6. Turn the voltage adjustment xxxx to the required value. Use the fine-tune xxxx if applicable. The C.V. indicator will light up on the display.
7. Connect the load to the output terminals. If the current exceeds the current-limiting point, the C.C. indicator will light up on the display.
Please refer to the Velleman LABPS5005 Lab Power Supply user manual for more detailed instructions and illustrations.
Add New Comment