User Manual Q&AAnswer
Mar 29, 2025 - 11:15 AM
To connect and set up the Snap One B-900-MOIP-4K-TX 900 Series 4K Media Over IP Receiver, please follow the steps below:
1. Ensure that you have read and understood the important safety instructions provided in the user guide.
2. Identify the appropriate location for the receiver. It should be installed away from water and heat sources such as radiators or stoves. Make sure to provide proper ventilation and avoid blocking any ventilation openings.
3. Connect the receiver to your display device (e.g., TV) using an HDMI cable. Plug one end of the HDMI cable into the HDMI output port on the receiver and the other end into the HDMI input port on your display device.
4. Connect the receiver to your network using an Ethernet cable. Plug one end of the Ethernet cable into the LAN port on the receiver and the other end into your network router or switch.
5. Connect the receiver to a power source using the provided power cord. Plug one end of the power cord into the power input port on the receiver and the other end into a standard electrical outlet.
6. Turn on your display device and select the appropriate HDMI input source.
7. Power on the receiver by pressing the power button located on the front panel. The receiver will go through a startup process, and the LED indicators on the front panel will indicate the status of the device.
8. Use the remote control or the control interface on your display device to access the receiver's menu and configure the settings according to your preferences. Refer to the user guide for detailed instructions on navigating the menu and adjusting settings.
9. Once the setup is complete, you should be able to enjoy 4K media content over IP through the Snap One B-900-MOIP-4K-TX receiver.
Note: If you encounter any issues during the setup process or while using the receiver, refer to the troubleshooting section in the user guide or contact qualified service personnel for assistance.
Add New Comment