Answer

Mar 29, 2025 - 11:02 AM
To connect the VADDIO EasyIP AMP D Network-Connected Amplifier to an analog speaker, follow these steps:
1. Ensure that the EasyIP AMP D is powered by either PoE+ or PoE. It can be powered by an EasyIP Switch or other PoE+ source for 25W output, or by a PoE source for 15W output.
2. Use a Cat-6 cable (included in the package) to connect the Network/PoE+ connector on the back of the EasyIP AMP D to the EasyIP Switch or PoE/PoE+ power injector.
3. Use a 2-conductor 5 mm Phoenix style plug (included in the package) to make a cable that connects the Speaker Output connector on the back of the EasyIP AMP D to the analog speaker.
4. Ensure that the cables are properly crimped and connected. Avoid using pass-through RJ-45 connectors, as they can cause intermittent connections and degraded signal quality.
5. Check the pin-out and continuity of the cables to ensure correct connections.
Once the connections are made, the EasyIP AMP D will bring the analog speaker into your EasyIP or Dante environment, allowing you to manage it using the Dante Controller application from Audinate.
Add New Comment