Answer

Mar 29, 2025 - 10:31 AM
To set up the C-CRANE CC Vector Long-Range Wifi Receiver Antenna System, follow these steps:
1. Assemble all items as pictured before proceeding.
2. Plug in the AC Power cord into the CC Vector Repeater and wait 1-2 minutes.
3. Configure Wirelessly: From your computer, tablet, smartphone, or WiFi device, go to the WiFi Settings/Connections and connect to the WiFi Network Name listed on the sticker underneath the CC Vector. Enter the WiFi Password when prompted.
- Alternatively, you can configure with an Ethernet Cable by connecting it to your computer's Ethernet port and to either of the CC Vector's Ethernet ports.
4. After completing Step 3, open the Internet Browser screen on your device and enter 192.168.18.1 into the Address Bar. Press "Enter" on your keyboard.
- Note: Your browser may show that you are not connected to the internet, but this is normal. Continue with the setup.
5. Adjust the orientation and placement of the USB antenna for better signal strength. Click "Rescan" to see if the signal improves.
6. If the network in Step 4 requires a password, enter the password when prompted. If not, proceed to the next step.
7. The system will reboot. Make sure your computer, phone, or tablet stays connected to "CCrane" and does not automatically connect to another WiFi network. If there is no response after 1 minute, close and re-open your web browser screen.
8. If the "Status" is "Connected" and "Internet Access" is "Yes", the setup is complete. Bookmark the setup page for future reference.
9. If the "Status" is "Connected" and "Internet Access" is "No", wait for 5 to 10 minutes. If there is no change, refer to "Troubleshooting and Tips" in the user manual.
Please note that these instructions are a summary. For more detailed information and troubleshooting tips, refer to the C-CRANE CC Vector Long-Range Wifi Receiver Antenna System User Manual.
Add New Comment