User Manual Q&AAnswer
Mar 29, 2025 - 05:08 AM
To configure the Oceanic Systems NMEA2000 Rudder Angle Adaptor for an American standard 240-30 Ohm sender, follow these steps:
1. Note the Rudder Instance Number set in the unit.
2. Set the Rudder Instance temporarily to "A".
3. Apply a small magnet to the marked area of the unit label for 2.5 seconds, then remove the magnet.
4. The LEDs will then flash normally configured for the correct sender type.
5. Return the Rudder Instance to its original position noted in step 1.
Note that the unit will flash the green Starboard LED if the unit is set to the American standard and the sender wire is temporarily disconnected.
If it is desired to return the configuration to a European Standard, repeat the above steps substituting "E" in step 2.
For more detailed information and illustrations, please refer to the Oceanic Systems NMEA2000 Rudder Angle Adaptor User Manual.
Add New Comment