Answer

Mar 29, 2025 - 05:03 AM
To install the Artwork Bodyshop TYPE-R FK8 17-21 Front Splitter, please follow these steps:
1. Gather the necessary tools, including a car jack and jack stands, a permanent marker, a drill, 5/16 drill bits, the provided hardware bag, and Torx, Phillips, and 10mm box wrenches (to remove your splash guard if necessary).
2. Jack up the front of your car and secure it with jack stands for easy access.
3. Align the front lip of the splitter under the bumper. The tip of the lip should be lined up with the corner of your bumper near the wheel.
4. Use a permanent marker to mark the drill spots on the bumper through the holes of the lip. If you can't reach the bumper with your marker, skip this step.
5. Drill holes in the middle of your marked spots using a 5/16 drill bit.
6. Create an easy access point to reach the holes inside the bumper. Assemble the lip with the provided hardware according to the assembly instructions.
7. Place the lip on the bumper, aligning the bolts through the drilled holes. Add the lock nuts over the bolts inside the bumper.
8. Tighten the bolts at the bottom of the splitter using a hex key.
9. Reinstall any removed trims.
10. You're now ready to rock and roll! Take pictures and send them to info@artworkbodyshop.com, and don't forget to tag Artwork Bodyshop on social media.
Please note that professional installation is strongly recommended for this product.
Add New Comment