Answer

Mar 27, 2025 - 03:18 AM
To install the Schneider Electric HMIDT643 Panel PC, follow these steps:
1. Ensure that you have the necessary tools and equipment for installation.
2. Choose a suitable flat surface for installation, such as a Type 1, Type 4X (Indoor Use Only), or Type 13 enclosure.
3. Mount the panel PC in an enclosure that provides a clean, dry, robust, and controlled environment.
4. Make sure the ambient air temperature and humidity are within the specified ranges.
5. Connect the power supply to the panel PC using the DC power supply connector provided.
6. Ensure that the ground wire is properly connected to the grounded terminal (FG) on the panel chassis.
7. Check the wiring route and make sure the power wires are not twisted or creating a short circuit.
8. Use a Phillips screwdriver to secure the panel PC to the panel using the installation fasteners provided. Gradually tighten the screws, alternating diagonally between screws until all are secure.
9. Verify that the L-shaped part of the installation fastener is completely vertical.
10. If necessary, replace the installation gasket on the rear of the display module. Use only the replacement gasket provided and insert it correctly into the groove for moisture resistance.
11. Once the panel PC is securely installed, you can power it on and start using it.
Please refer to the Schneider Electric HMIDT643 Panel PC User Guide for more detailed instructions and illustrations.
Add New Comment