Answer

Mar 27, 2025 - 03:09 AM
To install the LED High Bay light, please follow the instructions provided in the manual:
1. Disconnect power before installing the product or servicing it.
2. Install the hook onto the top hole of the fixture and rotate it to the end.
3. Fasten the xxxx nut tightly with a wrench.
4. Fasten the security xxxx .
5. Hook the product onto the designated location and fasten the security xxxx tightly.
6. Make all wiring connections.
7. Cap off dimming wires if not used.
Please ensure that you have fully read and understood the instructions in the manual before installing or using the product. It is important to follow the installation/wire diagram provided. Keep the manual for future reference and only use the product as described in the manual to avoid damaging the product or causing injury. If any problems occur, disconnect the product from the power source. Do not use the product if a part is damaged or defective; replace it immediately. If a non-standard consumer (power) installation is required, it should be performed by a qualified technician to reduce the risk of electric shock. Ensure the product is sufficiently ventilated during use and do not cover the LED light during usage to prevent heat damage. Avoid staring directly at the LED light as it can cause serious eye damage. Keep the product out of reach of children or animals.
For further support, you can visit the company's website at www.shada.nl/nl/contact.
Add New Comment