User Manual Q&AAnswer
Mar 27, 2025 - 02:52 AM
To link the V-TAC VT-2438 remote controller to your lights, please follow these instructions:
1. Switch off the light and wait for 10 seconds.
2. Switch on the light again.
3. When the light is on, short press any zone of the " " button three times within three seconds.
4. The light will blink three times slowly, indicating that the linking is done successfully.
If the light does not blink slowly, the linking has failed. In that case, please switch off the light again and repeat the above steps.
Note: The unlinking process is also provided in the manual if you need to unlink the remote controller from the lights. Additionally, you can group several lights by linking them to different zones on the remote controller.
For more detailed information and illustrations, please refer to the V-TAC VT-2438 Remote Controller Instruction Manual.
Add New Comment