Answer

Mar 27, 2025 - 02:46 AM
To install the different wire types in the SENCO YK0802 Fine Wire Stapler, follow these steps:
1. Ensure that the stapler is disconnected from any power source and that it is empty of staples.
2. Locate the appropriate wire type for your application. The manual provides a list of wire types and their corresponding part numbers.
3. Remove the front plate assembly by unscrewing the screws that hold it in place. Refer to the manual for the specific xxxx locations.
4. Remove the existing piston driver assembly by sliding it out of the stapler.
5. Insert the new piston driver assembly for the desired wire type into the stapler, making sure it is properly aligned.
6. Reattach the front plate assembly by screwing it back into place.
7. Repeat these steps for any additional wire types you wish to install.
Please note that it is important to use the correct wire type for your application to ensure proper stapler performance and avoid damage. Always refer to the manual for the specific part numbers and instructions for each wire type. If you have any further questions or need assistance, you can contact SENCO's toll-free Action-line at 1-800-543-4596 or email toolprof@senco.com.
Add New Comment