User Manual Q&AAnswer
Mar 26, 2025 - 12:28 PM
To install and connect the integrated flood sensor for the WATTS MasterSeries LF880V-FS Integrated Flood Sensor, you will need to follow the instructions provided in the Installation, Maintenance, and Repair Manual for the LF880V-FS and LF886V-FS series.
Here are the general steps for installing and connecting the flood sensor:
1. Obtain the add-on sensor connection kit for either building management systems (BMS) or cellular communication. This kit is required to activate the flood sensor.
2. Locate the flood sensor on the LF880V-FS assembly. The flood sensor is integrated into the assembly and is designed to detect excessive water discharges from the relief valve.
3. Connect the add-on sensor connection kit to the flood sensor. Follow the specific instructions provided in the installation manual for the correct wiring and connection procedures.
4. Once the add-on sensor connection kit is properly connected, the flood sensor will be activated. It will detect excessive water discharges from the relief valve and relay a signal.
5. Configure the multichannel alert system to receive notifications about potential flooding. The flood sensor can trigger alerts through calls, emails, or text messages. Refer to the installation manual for instructions on setting up the alert system.
Please note that the use of the integrated flood sensor does not replace the need to comply with all required instructions, codes, and regulations related to installation, operation, and maintenance of the product. It is important to provide proper drainage in the event of a discharge to prevent water damage. Also, keep in mind that Watts is not responsible for any failure of alerts due to connectivity or power issues.
For more detailed instructions and information, refer to the Installation, Maintenance, and Repair Manual for the LF880V-FS and LF886V-FS series provided by WATTS.
Add New Comment