Answer

Mar 26, 2025 - 09:36 AM
To connect your Sonance SONAMP1650 amplifier to your speakers, follow these steps:
1. Make sure the amplifier is turned off and the power switch on the rear panel is in the down position.
2. Connect your speakers to the Speaker Block Connectors on the amplifier. Use high-quality, 12-gauge speaker wire and make sure no bare wires come in contact with the amplifier chassis.
3. If you are using multiple speakers or zones, make sure to connect each speaker to its dedicated Speaker Output Block Connector.
4. If you are using the amplifier in bridged mode for higher power output, follow the instructions in the manual to bridge the channels and connect the speakers accordingly.
5. Once the speakers are connected, turn on the amplifier by pushing the power switch up to the ON position.
6. Adjust the volume output for each zone using the Zone Level controls on the rear panel of the amplifier.
7. Test the audio by playing music or a test tone through your audio source. If you do not hear any sound, refer to the troubleshooting section of the manual for further assistance.
Please refer to the complete owner's manual for detailed instructions and illustrations on connecting your specific setup.
Add New Comment