User Manual Q&AAnswer
Mar 26, 2025 - 08:24 AM
To install and connect the sentiotec CP-RB-090 Concept R Black sauna heater, please follow these steps:
1. Ensure that the power supply is disconnected before installing and connecting the sauna heater.
2. The installation should be performed by a qualified electrician or a similarly qualified person.
3. Install a fully disconnecting all-pole isolating device compliant with overvoltage category III on-site.
4. Use silicone cables that are heat-resistant up to 150 °C to connect the sauna heater.
5. Only install one sauna heater in the cabin and do not use it together with other sauna heaters.
6. The roof and walls of the sauna cabin must be made from low-resin, untreated or thermally treated wood, or from laminated wooden materials that do not give off formaldehyde. If other materials are used, they must be heat-resistant and corrosion-resistant.
7. The height of the sauna cabin must be at least 2.0 m.
8. Follow the specifications on volumes and ventilation of the sauna cabin as mentioned in chapter 10 of the instruction manual.
9. Position the sauna heater according to the minimum safety distances specified in chapter 4.2 of the manual.
10. Comply with the regulations applicable at the installation location.
11. If you encounter any problems during installation that are not explained in sufficient detail in the manual, consult your supplier for assistance.
Please note that these instructions are a summary, and it is important to refer to the complete instruction manual for detailed guidance and safety information.
Add New Comment