User Manual Q&AAnswer
Mar 26, 2025 - 08:15 AM
To install the LASENCHOO 8 Lights Modern Chandelier Light Fixture, please follow these steps:
1. Install the arms 2 on the top plate 1 using the lock nut and teeth lock washer 3.
2. Connect all the wires in parallel using connectors 4. Use one connector for all live wires (L) and another connector for all neutral wires (N).
How to use the splicing connector:
- Cut into the wire's insulation 10mm without cutting the wire itself.
- Pull the orange operating handle A to open the inlet hole 90°.
- Insert the wire B into the end of the hole.
- Press the operating handle A to secure the wire. Ensure that the wire cannot be pulled out.
- Repeat this process for all the wires. Note that one inlet hole can accept 0.08-2.5mm² wire, so you can insert 2-3 wires into one inlet hole.
Note:
- The operating handle A must be kept at a 90° angle when open. Be careful not to hurt your fingers when closing the handle.
- The splicing connector is designed for parallel wire connection, so one connector can only connect all live wires or all neutral wires. Do not mix live and neutral wires in one connector.
How to use the cap connector:
- Prepare the bare ends of the wires and twist them together.
- Place the plastic wire cap onto the ends of the wires.
- Rotate the wire cap clockwise to secure the wires. Use a lock tie to further secure the wires.
Note:
- The cap connector is designed for parallel wire connection, so one connector can only connect all live wires or all neutral wires. Do not mix live and neutral wires in one connector.
- We suggest using electrical tape to secure each connector cap onto its respective wire.
3. Install the metal box 5 to the plate 1 with end cap 6.
4. Pass the wire through tube 7 and tube 8, and rotate the tubes to fasten them to the fixture.
5. Pass the wire through the ring 10 of the hanging chain 9. Rotate the ring 10 to secure the chain 9 to the fixture. Connect the chain 9 with the canopy 11 using the carabiner hook xxxx connection 12. Pass the wire through the chain 9 and canopy 12.
6. Install the bracket 13 to the ceiling junction box using screws.
7. Connect the wire with connector 14 to your home line.
8. Install the fixture to the bracket using cap nuts 15.
9. Place the cylinder tube 16 on the bulb holder and then install the bulbs 17.
Please ensure that you read the entire instruction manual carefully before installation. If you encounter any issues or have further questions, please contact us for professional suggestions or video assistance.
Add New Comment