User Manual Q&AAnswer
Mar 26, 2025 - 07:58 AM
To install the LEDone 5114179 MW Troffer Retrofit Kit, please follow these steps:
1. Safety Precautions:
- Read the installation instructions carefully before starting.
- Ensure that all wiring is done by a qualified electrician.
- Disconnect power before installing or servicing the fixture.
- Make sure the power is OFF before installation or maintenance.
- Only install the kit in luminaires that meet the specified construction features and dimensions.
- Do not make or alter any open holes in the enclosure of wiring or electrical components during installation.
2. Cleaning & Maintenance:
- Ensure the fixture is cool to touch before cleaning or maintenance.
- Clean the glass lens with a non-abrasive glass cleaning solution.
- Do not open the fixture to clean the LED, and do not touch the LED.
3. Troubleshooting:
- Check that the line voltage at the fixture is correct.
- Ensure the fixture is properly grounded.
4. Wattage & Color Temperature Selection:
- Select the appropriate wattage and color temperature for your needs.
5. Installation:
- Remove the existing fixture frame and clear out the inside of the existing housing.
- Install the bracket in the existing housing between the housing and tee-grid bar.
- Slide the bracket to both sides and secure it.
- Install the flat bottom side to one of the brackets, fix the supplemental supports, and connect the circuit.
- Close the retrofit fixture and secure the latch to ensure it is completely secure.
- Verify that the installation is complete.
6. 0-10V Dimmable Wiring:
- The universal voltage driver allows operation from 120V to 277V, 50/60Hz.
- For 0-10V dimming, follow the wiring instructions provided in Figure 7 of the manual.
- Connect the appropriate fixture leads to the corresponding supply leads and dimming leads.
- Ensure the ground wire from the fixture is connected to the supply ground, not the output ground.
- If the dimmable leads are unused, make sure they are properly capped.
For further assistance or more detailed instructions, please refer to the LEDone 5114179 MW Troffer Retrofit Kit Installation Guide.
Add New Comment