Answer

Mar 26, 2025 - 05:08 AM
To install the Uolfin 5106265 Solandar Matte Black with Clear Cylinder Glass Modern-Contemporary Seeded Glass Cylinder Mini Pendant Light, please follow these steps:
1. Before starting, make sure to turn off the electricity by going to the main fuse or circuit breaker box in your home and placing the main power switch in the "OFF" position.
2. Ensure that the mounting surface is clean, dry, flat, and strong enough to support the weight of the lamp. It should also be 1/4" larger than the canopy on all sides. Correct any gaps between the mounting surface and canopy exceeding 3/16" as required.
3. Check that the voltage you are using is 120V, and the maximum wattage is 60W per bulb.
4. Carefully align the iron ring (M), glass shade (N), and iron frame (O), then secure them with screws (K). Switch to the other side of the glass shade (N) and align the socket (L), glass shade (N), and iron ring (M). Secure them with screws (K).
5. Determine the correct number of links needed for the desired hanging height. Use chain pliers to disconnect and discard any unwanted parts of the chain.
6. Attach the quick link (H) to the chain (I) and loop (J) on the top of the socket (L).
7. Weave the fixture wires through the chain (I) in and out of every other link, stopping just when you reach the top of the chain (I). Gently pull the wires to ensure they are not stressed.
8. Remove the collar ring (F) from the collar loop (G). Attach the single bar (C) to the outlet box using the mounting screws (B). Make sure the side of the single bar (C) marked "GND" faces out.
9. Raise the canopy (E) over the collar loop (G) and xxxx the collar ring (F) to measure a proper position. Unscrew the collar ring (F) from the collar loop (G) and remove the canopy (E). Adjust the collar loop (G) on the single bar assembly (C) by screwing it in or out until the secure length is achieved.
10. Pass the chain (I) through the collar ring (F) and then through the canopy (E).
11. Open the quick link (H), attach it to the collar loop (G), and close it. Pass the fixture wires through the collar loop (G) to the top of the pre-assembled threaded xxxx , ensuring the wires are not stressed.
12. If needed, shorten the length of the fixture wires, leaving at least 6" above the single bar (C).
13. Make wire connections according to the provided chart. Twist wires together with plastic wire connectors until tightly joined, and wrap each connector with approved electrical tape. Ensure no wire strands are exposed and tuck all wires into the outlet box.
14. Raise the canopy (E) to the ceiling and secure it in place by tightening the collar ring (F) onto the collar loop (G).
15. Install the bulb (not included) into the socket, making sure not to exceed the maximum recommended wattage.
16. Double-check that everything is installed properly before turning on the light.
For any further assistance or inquiries, you can contact Uolfin customer support at +1 850 296 2377 during working hours (Mon - Fri 9:00 - 16:00 EST) or email them at uolfin@newdecorworld.com.
Add New Comment