Answer

Mar 26, 2025 - 04:28 AM
To install the ZURN 600XL Water Pressure Reducing Valve, follow these steps:
1. Ensure that the valve is suitable for your application and meets the requirements of your local codes.
2. Determine the appropriate location for installation. The valve can be installed in any position.
3. If installing in a pit, vault, or inside application, specify the "SC" sealed cage option.
4. Prepare the water line by cutting and cleaning the pipe ends.
5. Apply thread sealant tape or pipe joint compound to the male threads of the valve and the pipe connections.
6. Connect the valve to the water line using the appropriate fittings. The valve is available with different connection options, such as single union or less union.
7. Tighten the fittings securely using a wrench, but avoid over-tightening.
8. If desired, the valve can be tapped and plugged for a pressure gauge.
9. Once the valve is installed, it is important to adjust the pressure setting. Use a pressure gauge downstream of the valve to verify the correct pressure setting.
10. To adjust the pressure, use the adjustment bolt on the bell housing. Do not bottom out the adjustment bolt.
11. After adjusting the pressure, monitor the system to ensure that it is functioning properly and maintaining the desired pressure.
For more detailed instructions and illustrations, refer to the ZURN 600XL Water Pressure Reducing Valve Instructions provided with the product.
Add New Comment