Answer

Mar 26, 2025 - 04:07 AM
The installation process for the EGLO 31714 LED Panel Light is straightforward and can be easily done by following the steps outlined in the instruction manual. Here is a step-by-step guide:
1. Ensure that the power supply is turned off before starting the installation process.
2. Remove the existing light fixture, if applicable, by unscrewing the screws or clips that hold it in place. Disconnect any electrical connections.
3. Take the EGLO 31714 LED Panel Light out of its packaging and carefully inspect it for any damage. If you notice any damage, do not proceed with the installation and contact the manufacturer or retailer for assistance.
4. Attach the mounting brackets to the ceiling or wall using the provided screws and a suitable screwdriver. Make sure the brackets are securely fastened.
5. Connect the electrical wires from the power supply to the corresponding wires on the LED panel light. Follow the color-coding or labeling on the wires to ensure proper connections. Use wire connectors or electrical tape to secure the connections.
6. Carefully position the LED panel light onto the mounting brackets, ensuring that it is aligned properly. Secure the light in place by tightening the screws on the brackets.
7. Turn on the power supply and test the LED panel light to ensure it is functioning correctly. If it does not turn on or there are any issues, double-check the wiring connections and consult the troubleshooting section of the instruction manual.
8. Once the installation is complete and the LED panel light is working properly, clean the surface of the light with a soft, dry cloth to remove any fingerprints or dust.
Please note that this is a general guide, and it is essential to refer to the specific instructions provided in the EGLO 31714 LED Panel Light Instruction Manual for accurate and detailed installation steps.
Add New Comment