Answer

Mar 26, 2025 - 03:44 AM
To install and connect the Paxton ins-20006-AE Door Controller, please follow these steps:
1. Ensure that only qualified and trained personnel, who are familiar with this type of product and fully understand the instructions, perform the installation, connection, or testing of the equipment.
2. The equipment is intended for indoor use only in dry locations. It is classified as a Class A product, which means that in a domestic environment, it may cause radio interference. If interference occurs, take appropriate measures to mitigate it.
3. The installation must comply with National Wiring Regulations and IEC62368-1 standards.
4. Incorporate a readily accessible disconnect device in the building wiring, including an appropriately rated circuit breaker with at least a 3.0 mm contact gap to disconnect both poles. After switch off, all internal capacitors will discharge to safe levels within 60 seconds under normal conditions. However, under fault conditions, charge may be held for longer, so take suitable precautions before handling the unit.
5. Use a protection device with fusing characteristics of T3.15AH250V.
Please note that this answer provides a general overview of the installation process. For detailed instructions and safety precautions, refer to the Paxton ins-20006-AE Door Controller User Guide.
Add New Comment