How do I install the LUMASCAPE Vedita Downlight Luminaire? (LUMASCAPE Vedita Downlight Luminaire Instruction Manual)

Answer

manuals.plus

Mar 26, 2025 - 03:09 AM

To install the LUMASCAPE LS9404LED Vedita Downlight Luminaire, follow these steps:

1. Use a Lumascape supplied 24 V DC ripple-free power supply or transformer, located centrally in relation to the luminaires. Note that electronic transformers should not be used as they may damage the product.

2. Mark the locations of the luminaires and use the hole saw supplied to drill a hole in the ceiling or cavity wall.

3. Fold the legs up on the ceiling clip and insert it into the hole. Feed the LS9404LED cable through the mounting clip.

4. Calculate the distances, wire gauge, and power supply sizes. Lay the cable from the power supply/transformer for each cable run. If dimming is required, four conductors will be needed. For non-dimmed installations, only two conductors are required.

5. Connect the luminaire to the supply cable using the wire nuts supplied. Ensure that any joint is dry and watertight to avoid voiding the warranty. Note that the orange and grey wires are for optional PWM digital dimming using 0-10 V.

6. Switch on the power and check that each luminaire is operating.

7. If dimming is not required, do not connect the orange and grey wires. Seal and keep them dry to prevent the intelligent driver from dimming the luminaire due to a voltage differential between the conductors.

8. Press the LS9404LED fully into the mounting clip.

For more detailed specifications and instructions on fine-tuning the brightness of the luminaire, refer to the instruction sheet IN0059US "How to adjust the brightness for your d5 equipped luminaire.