Answer

Mar 26, 2025 - 02:43 AM
To install and use the Brio CL500 water dispenser cooler, please follow these steps:
1. Keep the cooler unplugged until water flows all the way through the faucets.
2. Ensure the dispenser stands upright for a minimum of 2 hours before loading the water bottle.
3. Place the dispenser a minimum of 4 inches away from the wall to ensure ventilation.
4. Install the dispenser on a level floor strong enough to support it when fully loaded.
5. Do not install the dispenser where it will be subject to direct sunlight, heat, or moisture.
6. Wipe down the water bottle cap and neck to ensure there is no debris.
7. Remove the cap seal on the top of the bottle cap (if necessary), but do not remove the plastic cap of the bottle.
8. Invert the bottle and place it into the top of the No-Spill System. As the water fills the reservoirs inside the machine, the water leaving the bottle will be replaced with air seen as bubbles rising in the bottle. This is normal and will stop when the reservoir is filled. This process will repeat itself each time water is drawn from the dispenser.
9. After installing a bottle, remove the air inside the Hot Water Tank by pressing and holding the Hot Water Lever until water starts to come out of the water outlet. Place a cup under the hot dispenser faucet. Squeeze the front and back of the left faucet handle together and push down until water flows continuously. Depress the cold water faucet to make sure there is a continuous flow of water.
Please refer to the user manual for additional instructions and safety precautions.
Add New Comment