User Manual Q&AAnswer
Mar 26, 2025 - 02:36 AM
To install the Hunter 99106 Simple Connect Add-On Receiver, please follow these steps:
1. Before starting the installation, make sure the fan is set to HIGH speed and the light is turned ON using the pull chains, if your fan has them. Also, ensure that power is OFF at the circuit breaker.
2. Remove the canopy of the fan. If you're unsure how to do this, refer to the fan's owner's manual. Take note of the existing wire connections or take a photo for reference. Remove the wire connectors that connect the wires from the outlet box to the fan, but leave the grounding wires connected.
3. Choose the hanging system that matches your fan and place the receiver as shown. Note that this receiver cannot be installed with any other receiver or hard-wired wall control.
4. If the canopy is crowded with excess wire, you may cut the excess fan wires, leaving a minimum of 8 inches remaining. Strip the fan lead wires by 1/2 inch and place the remaining excess wire into the ceiling electrical box. Ensure that the bracket and fan remain properly grounded.
5. Connect the wires from the receiver to the wires from the fan. Use wire connectors to connect the blue wire from the receiver to the light wire (blue or possibly black with white stripe) from the fan. Connect the yellow wire from the receiver to the motor wire (black) from the fan. If you're unsure about wire colors or connections, it's best to consult a qualified electrician.
6. Connect the wires from the receiver and fan to the wires from the ceiling. Use wire connectors to connect the black wire (ungrounded) from the ceiling to the black wire from the receiver. Connect the white wire (grounded) from the ceiling to both the white wire from the receiver and the white wire from the fan. Again, if you're unsure about wire colors or connections, consult a qualified electrician.
7. Once all the wires are connected and secured with wire connectors, reinstall the canopy following the instructions in the fan's owner's manual.
8. Restore power at the circuit breaker.
Congratulations! You have successfully installed your add-on receiver. To continue setup and add the fan to your Simple Connect programmable control, visit the info screen in the app.
Please note that for safety reasons, always disconnect the power before installing or servicing the fan. If you're unable to lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.
Add New Comment