How do I program the ELSEMA Penta Receiver with my remote control? (ELSEMA 2-Channel Penta Receiver User Guide)

Answer

manuals.plus

Mar 25, 2025 - 11:05 AM

To program the ELSEMA PCR43302P receiver with your remote control, you have two options: Remote to Receiver and Remote to Remote programming.

1. Remote to Receiver programming:
a. Make sure all switches are "OFF" on the receiver's 12-way dip switch.
b. Press and hold the program button on the receiver.
c. Press the button on your remote control for 2 seconds. The receiver LED will flash and then turn green.
d. Release the buttons on both the receiver and the remote.
e. Press the button on your remote control to test the receiver output.

2. Remote to Remote programming:
a. Open the case of a remote control that is already programmed and press and release the program button on the back of the board. This puts the receiver into learning mode.
b. Press the button of the remote control from step 1, which activates the receiver.
c. Press the button on the new remote control that needs to be programmed for 2 seconds.
d. Press the program button again on the remote control from step 1 to exit learning mode.
e. Press the button on the new remote control to test the receiver output.

Note: If your receiver does not have a red marking, follow these steps instead:
a. Open the case of a remote control that is already programmed and press and release the program button on the back of the board.
b. Press the button on the new remote control for 2 seconds.
c. Press the button on the new remote control again to test the receiver output.

For further information and additional programming options, please refer to the ELSEMA PCR43302P 2-Channel 433MHz Penta Receiver User Guide.