Answer

Mar 25, 2025 - 10:45 AM
To adjust the wetness or dryness of the foam, follow these steps:
1. Close the needle valve (NV18) completely by turning the handle (NV1032HNDL) in a clockwise direction until it stops.
2. Open the needle valve (NV18) by turning the handle (NV1032HNDL) in a counter-clockwise direction for three complete turns.
3. Continue to open the needle valve (NV18) by turning the handle (NV1032HNDL) counter-clockwise in ¼ turn increments, allowing 30 seconds between adjustments, until the desired consistency of foam is achieved.
By adjusting the needle valve, you can control the amount of foam produced, ranging from wet to dry foam.
Add New Comment