Answer

Mar 25, 2025 - 09:14 AM
To install the INTIEL DT 3.2.2 Programmable Controller for Solar, please follow these steps:
1. Before installation, check the integrity of the unit and its connecting wires.
2. Make sure to read the product manual thoroughly before installation and disassembly.
3. The installation and disassembly of the unit should be carried out by qualified personnel.
4. Mount the controller in a dry and ventilated place away from heat sources and flammable gases or liquids.
5. Ensure that the mains voltage matches the voltage on the rating plate of the unit.
6. Connect the sensors (Pt 1000) to the appropriate terminals on the controller.
7. Connect the power supply to the phase and zero terminals on the controller.
8. If using electric heaters, connect them to the designated terminals on the controller.
9. If using a standard pump, connect it to the relay output terminals on the controller. For high-efficiency pumps, follow the specific instructions for PWM or DCV control.
10. If necessary, install additional components such as check valves or shut-off valves according to your specific system requirements.
11. Once the installation is complete, ensure that all connections are secure and properly insulated.
12. Test the system to ensure proper functionality and consult the user guide for further programming and customization options.
Please note that these instructions are a general overview and it is important to refer to the product manual for detailed installation instructions and safety precautions.
Add New Comment