How to properly install body decals on RC4WD Toyota 4Runner Hard Body Complete Set? (RC4WD Toyota 4Runner Hard Body Complete Set Owner's Manual)

Answer

manuals.plus

Mar 25, 2025 - 08:13 AM

To properly install the body decals on the RC4WD 1985 Toyota 4Runner Hard Body Complete Set, please follow these steps:

Step 1: Clean the surface - Before applying the decals, make sure the surface of the body is clean and free from any dust or debris. You can use a mild soap and water solution to clean the surface, followed by drying it thoroughly.

Step 2: Cut out the decals - Carefully cut out the decals from the decal sheet using a pair of scissors or a hobby knife. Leave a small border around each decal to make it easier to handle.

Step 3: Prepare the decals - Fill a bowl or basin with warm water and add a small amount of dish soap. Gently place the decals in the water and let them soak for about 30 seconds to loosen the adhesive backing.

Step 4: Apply the decals - Carefully remove one decal from the water and slide it onto the desired location on the body. Use your fingers or a soft cloth to position the decal correctly and remove any air bubbles or excess water. Repeat this process for all the decals.

Step 5: Settle the decals - Once all the decals are applied, use a soft cloth or paper towel to gently press down on the decals, ensuring they adhere properly to the body. Be careful not to apply too much pressure, as it may damage the decals.

Step 6: Allow drying time - Let the decals dry completely before handling or applying any additional pressure. This will ensure that the decals stay in place and maintain their appearance.

Note: It is recommended to refer to the instruction manual for any specific guidelines or tips regarding the installation of body decals on the RC4WD 1985 Toyota 4Runner Hard Body Complete Set.