Answer

Mar 22, 2025 - 04:17 AM
To load nails into the DRAPER 14607 10-50mm Air Nailer, follow these steps:
1. Disconnect the tool from the air supply.
2. Press the magazine latch and gently slide the magazine back.
3. Lay the tool on its side and place a strip of nails against the center bar of the magazine, ensuring the point of the fastener is facing forwards/down.
4. Close the magazine and ensure the latch correctly engages and is fully secure.
5. Connect the tool to the air supply.
Always test that the fastener penetrates by the correct amount by driving the fastener into a piece of wood. If needed, the air pressure can be regulated to the desired level, as specified in the manual. Make sure not to exceed the maximum pressure of 115psi/7bar.
Please note that it is important to disconnect the tool from the air supply before any adjustment or maintenance is carried out.
Add New Comment