How do I install the Uolfin Antique Brass Vanity Light 3 Light? (Uolfin Antique Brass Vanity Light 3 Light Instruction Manual)

Answer

manuals.plus

Mar 22, 2025 - 02:21 AM


To install the Uolfin A04787W4 Antique Brass Vanity Light 3 Light, please follow the steps below:

1. Safety Precautions:
- We recommend hiring a licensed electrician for installation.
- Read the instruction manual carefully and keep it for future reference.
- Before starting any work, always turn off the electricity at the main fuse or circuit breaker box.
- Ensure the wall switch is also turned off.
- The mounting surface should be clean, dry, flat, and strong enough to support the light.
- Make sure the ceiling or wall can bear the weight of the lamp.
- Use a voltage of 120V and a maximum wattage of Type B, Max 40W per bulb.
- Keep the lamp away from acidic and alkaline substances.
- When replacing bulbs, turn off or unplug the lamp and wait until it is cool.

2. Tools Required:
- The manual does not specify the exact tools required, but the provided image shows a screwdriver and wire connectors. Additional tools may be necessary based on your specific installation requirements.

3. Parts Included:
- (C) Mounting plate (1)
- (D) Green ground  xxxx  (1)
- (E) Back plate (1)
- (F) Stud (2)
- (G) Socket (4)
- (H)  xxxx  (12)
- (I) Glass shade (4)

4. Assembly and Installation Instructions:
- Carefully unpack the fixture and ensure all parts and accessories are included.
- Turn off the power at the main fuse or circuit breaker box and the wall switch.
- Unscrew the studs (F) from the back plate (E) and set them aside.
- Pass the supply wires from the outlet box through the mounting plate (C) and secure it to the outlet box using the provided mounting screws (A).
- Make wire connections according to the provided chart, ensuring the ground wire is connected properly.
- Twist the wires together with plastic wire connectors and wrap each connector with approved electrical tape. Ensure no wire strands are exposed and tuck all wires into the outlet box.
- Align the holes in the back plate (E) and mounting plate (C), then secure them with the previously removed studs (F).
- Install bulbs (not included) by removing screws (H) from sockets (G), placing the glass shades (I) on the sockets, and securing them with screws (H).
- Double-check that everything is installed properly before turning on the light.

For any further questions or concerns, you can contact Uolfin customer support at +1 850 296 2377 during working hours (Mon - Fri 9:00 - 16:00 EST) or email them at uolfin@newdecorworld.com.