Answer

Mar 22, 2025 - 01:59 AM
To install the Uolfin 5069678 5-Light Matte Black and Bell Glass Shape fixture, please follow the steps outlined in the instruction manual:
1. Before starting the installation, ensure that the electricity is turned off. Go to the main fuse or circuit breaker box in your home and place the main power switch in the "OFF" position. Also, turn off the wall switch.
2. Make sure the mounting surface is clean, dry, flat, and strong enough to support the weight of the lamp. The surface should be 1/4" larger than the canopy on all sides. Correct any gaps exceeding 3/16" as required.
3. Confirm that the voltage you are using is 120V, and the maximum wattage per bulb is 40W.
4. Keep the lamp away from acidic and basic objects to avoid damaging the surface.
5. When replacing bulbs, always turn off or unplug the lamp and wait until it is cool, as bulbs can get hot quickly.
6. The instruction manual provides a list of tools required for assembly and installation. Make sure you have these tools on hand before starting.
7. The manual also includes a list of parts and accessories included with the fixture. Check that all parts are present before proceeding.
8. The assembly and installation instructions are divided into steps. Follow each step carefully.
9. Pre-installation: Choose the desired hanging height and use the stems (I) accordingly. Pass the wires and ground wire through the stem (I) and twist it onto the iron tube (J). Attach the quick link (G) to connect the stem (I) and the loop (H) on the top of the stem.
10. Fix the glass plate (L) to the iron lining (M) using the provided xxxx (K).
11. Turn off the power before starting the installation. Follow the instructions in the manual to shut off the electricity.
12. Install the mounting plate assembly (C) to the ceiling using the provided mounting screws (B).
13. If needed, cut off the excess wire length of the fixture, leaving at least 6" measured from the top mounting plate assembly (C).
14. Make wire connections according to the wire color chart provided in the manual. Ensure that the ground wire is connected properly.
15. Twist the plastic wire connectors until the wires are tightly joined together, and wrap each connector with approved electrical tape. Ensure that no wire strands are exposed and tuck all wires into the outlet box.
16. Raise the canopy (E) to the ceiling and secure it in place by tightening the xxxx nut (F) onto the threaded xxxx on the mounting plate assembly (C).
17. Install bulbs (not included) according to the recommended maximum capacity on the socket.
18. Double-check that everything is installed properly before turning on the light.
For further assistance or to order replacement parts, you can contact Uolfin at uolfin@newdecorworld.com or call +1 850 296 2377 during working hours (Mon - Fri, 9:00 a.m. - 16:00 p.m. EST).
Add New Comment