User Manual Q&AAnswer
Mar 22, 2025 - 12:31 AM
To install the Uolfin 5069610 4-Light Brushed Gold with Geometric Shape Modern-Contemporary Cage Chandelier, please follow the step-by-step instructions provided in the manual:
1. Safety Precautions:
- It is recommended to have a licensed electrician perform the installation.
- Turn off the main power switch and wall switch before starting any work.
- Ensure the mounting surface is clean, dry, flat, and strong enough to support the chandelier.
- Verify that the voltage is 120V and the maximum wattage per bulb is 40W.
- Keep the chandelier away from acidic and alkaline substances.
- When replacing bulbs, turn off or unplug the chandelier and wait for it to cool down.
2. Tools Required (not included):
- Wire connector
- Mounting xxxx
3. Parts Included:
- Single bar (C)
- Green ground xxxx (D)
- Canopy (E)
- Collar ring (F)
- Collar loop (G)
- Quick link (H)
- Chain (I)
- Loop (J)
- Fixture loop assembly (K)
- Iron frame (L)
- Tube (M)
- Arm (N)
4. Assembly and Installation Instructions:
- Carefully unpack the chandelier and ensure all parts and accessories are included.
- Adjust the arms (N) and iron frames (L) to the proper position.
- xxxx the loop (J) onto the fixture loop assembly (K).
- Determine the correct number of links needed for the desired hanging height and remove any excess using chain pliers.
- Attach the quick link (H) to the chain (I) and loop (J) on the top of the fixture loop assembly (K).
- Carefully weave the fixture wires through the chain (I) in and out of every other link, stopping just before reaching the top of the chain.
- Turn off the power at the main fuse or circuit breaker box.
- Attach the single bar (C) to the outlet box using the mounting screws (B), ensuring that the side marked "GND" faces outwards.
- Raise the canopy (E) over the collar loop (G) and xxxx the collar ring (F) to measure the proper position. Unscrew the collar ring (F) and remove the canopy (E).
- Pass the chain (I) through the collar ring (F) and then through the canopy (E).
- Open the quick link (H), attach it to the collar loop (G), and close it. Pass the fixture wires through the collar loop (G) to the top of the pre-assembled threaded xxxx .
- If needed, shorten the length of the fixture wires, ensuring at least 6" of remaining wire length above the single bar (C).
- Make wire connections according to the provided chart, ensuring the ground wire is connected correctly.
- Twist the wires together with a plastic wire connector and wrap each connector with electrical tape. Tuck all wires into the outlet box.
- Raise the canopy (E) to the ceiling and secure it in place by tightening the collar ring (F) onto the collar loop (G).
- Install bulbs (not included) according to the recommended maximum wattage.
- Double-check that everything is installed properly before turning on the light.
For further assistance or to order replacement parts, you can contact Uolfin at uolfin@newdecorworld.com or call +1 850 296 2377 during working hours (Mon - Fri, 9:00 a.m. - 16:00 p.m. EST).
Add New Comment