Answer

Mar 21, 2025 - 11:38 PM
To install the 10L0L Y149 Steering Wheel Mounting Adapter, please follow these steps:
1. Park the vehicle on level ground.
2. Turn the key to the "OFF" position and remove it from the switch.
3. Make sure the parking brake is set.
4. Remove the 6 screws with the hex-head spanner. Refer to figure 2 in the manual.
5. Remove the steering wheel. Refer to figure 3.
6. Remove the xxxx on the bar using a 24mm (7/8 inch) socket. Refer to figure 4.
7. Use a hammer to gently loosen the bar so that the mounting adapter can be removed smoothly. Refer to figure 5.
8. Remove the steering wheel mounting adapter. Refer to figure 6.
9. Install the mounting adapter. Adjust the steering wheel mounting adapter to keep it in a straight direction (Make sure the hole ① is located exactly right ahead). Refer to figure 7.
10. Put the steering wheel on the mounting adapter, then install the 6 screws with the hex-head spanner. Refer to figure 8.
Following these steps will complete the installation of the 10L0L Y149 Steering Wheel Mounting Adapter. If you require further technical support, you can reach out to the manufacturer via their website, email, Facebook, or YouTube channels mentioned in the manual.
Add New Comment