User Manual Q&AAnswer
Mar 21, 2025 - 12:31 PM
Attaching and removing a filter bag for the Riptide XP Pool Vacuum System is a simple process. Here are the steps:
1. To attach the bag, start on the opposite side from where you are standing and snap the groove in the bag ring onto the ridge on the vacuum head. Make sure not to put the orange ring below the ridge.
2. Snap the ridge into the groove on the bag ring, starting from the opposite side.
3. Slide your hands back to the center of the ring and push down. This will bend the ring in the middle, and the bottom flange will stretch over the ridge.
4. Keep pushing down until the bottom flange stretches over the ridge and snaps on. Make sure to push down on the center of the ring.
To remove the bag:
1. Put your two thumbs together and push on the top flange of the bag.
2. Place your fingers under the bottom flange and twist the flange. Do not pull up, but instead, keep twisting the flange until the bag releases from the ridge on the vacuum head.
Please note that if you are having difficulty attaching or removing the bag, you can visit the manufacturer's website to watch an instructional video for a visual demonstration of the process.
Add New Comment