User Manual Q&AAnswer
Mar 21, 2025 - 12:06 PM
To install the Dainolite PYA-224C 4-Light White Modern/Contemporary Drum Pendant Light, please follow the steps outlined in the installation guide provided by Dainolite. Here is a complete guide on how to install the pendant light:
1. Before starting the installation, ensure that the power to the circuit is turned off at the breaker panel.
2. Carefully unpack the pendant light and ensure that all the necessary components are included.
3. Determine the desired location for the pendant light and mark the spot on the ceiling where the light will be installed.
4. Install the mounting bracket onto the electrical box in the ceiling using the provided screws. Ensure that the bracket is securely attached.
5. Connect the electrical wires from the pendant light to the corresponding wires in the electrical box. Match the black wire from the pendant light to the black (hot) wire in the electrical box, the white wire from the pendant light to the white (neutral) wire in the electrical box, and the green or bare copper wire from the pendant light to the ground wire in the electrical box. Use wire nuts to secure the connections.
6. Carefully lift the pendant light and align it with the mounting bracket. Insert the screws through the holes in the canopy of the pendant light and tighten them into the mounting bracket to secure the light in place.
7. Once the pendant light is securely installed, restore power to the circuit by turning on the breaker.
8. Test the pendant light by turning on the switch. If the light does not turn on, double-check the connections and ensure that the power is properly restored.
Please note that this is a general guide, and it is always recommended to refer to the specific installation instructions provided by Dainolite for your model, as they may contain additional or model-specific steps. If you have any further questions or concerns, it is best to reach out to Dainolite directly through their contact information provided.
Add New Comment