User Manual Q&AAnswer
Mar 21, 2025 - 11:45 AM
To install the T238 V2 Digital Trigger Unit V2.0 Bluetooth Version in your gel ball blaster, follow these steps:
1. Shim the gears before installation to avoid damaging the gear sensor.
2. Disassemble the gearbox, taking off the cut-off lever and the safety lever, but keep the selector plate on the gearbox.
3. Paste the insulation sticker provided in the corresponding position on the circuit board surface.
4. If your gearbox is not a gel ball gearbox, you can remove two power lines for the magazine.
5. Install the module and push the wires into the gearbox (some gearboxes may require cutting off the stiffener or drilling a hole).
6. Assemble the gearbox.
For more detailed instructions and illustrations, please refer to the instruction manual provided with the product.
Note: It is recommended to seek professional help if you are not familiar with soldering or disassembling and assembling automatic electric guns.
Add New Comment