User Manual Q&AAnswer
Mar 21, 2025 - 10:50 AM
Installation of the Dainolite PIA-213FH Pietra 3-Light 21 Inch Black Incandescent Flush Mount Light can be done by following these steps:
1. Ensure that the power is turned off at the circuit breaker before starting the installation process.
2. Open the package and check if all the necessary components are included. The components typically include the light fixture, mounting bracket, screws, and installation instructions.
3. Determine the location where you want to install the flush mount light. Make sure the surface is flat and suitable for mounting.
4. Attach the mounting bracket to the electrical box on the ceiling using the provided screws. Ensure that the bracket is securely fastened.
5. Connect the wiring. The light fixture should have three wires - black (hot), white (neutral), and green or bare (ground). Connect the black wire from the fixture to the black wire from the electrical box, the white wire to the white wire, and the green or bare wire to the grounding wire or xxxx .
6. Carefully tuck the connected wires into the electrical box and position the fixture over the mounting bracket. Align the xxxx holes on the fixture with the holes on the bracket.
7. Insert and tighten the screws to secure the fixture to the mounting bracket. Make sure the fixture is level and securely attached.
8. Install the light bulbs. The Dainolite PIA-213FH Pietra Flush Mount Light requires three E26 base bulbs with a maximum wattage of 60W each. These bulbs are not included in the package, so you will need to purchase them separately.
9. Once the installation is complete, turn the power back on at the circuit breaker and test the light to ensure it is functioning properly.
If you have any further questions or encounter any difficulties during the installation process, you can contact Dainolite directly using the provided contact information.
Add New Comment