User Manual Q&AAnswer
Mar 21, 2025 - 10:45 AM
To install the Dainolite PHA-241P-MB-500 Philomena Grey Transitional Cone Pendant Light, please follow the steps below:
1. Before starting the installation, make sure the power to the circuit is turned off at the breaker panel.
2. Remove the existing light fixture, if applicable, by disconnecting the wires and removing any mounting hardware.
3. Carefully unpack the pendant light and ensure all parts are included. The package should contain the pendant shade, canopy, mounting hardware, and installation instructions.
4. Attach the canopy to the ceiling using the provided screws and mounting bracket. Ensure the canopy is securely fastened to the ceiling.
5. Connect the wires from the ceiling to the wires of the pendant light. Match the black wire from the ceiling to the black wire from the pendant light, and the white wire from the ceiling to the white wire from the pendant light. Use wire nuts to secure the connections and ensure they are tight.
6. If your pendant light has a grounding wire, connect it to the grounding wire from the ceiling using a wire nut. If there is no grounding wire, consult a licensed electrician for proper grounding.
7. Carefully tuck the wires into the electrical box and ensure they are not pinched or exposed.
8. Attach the pendant shade to the canopy using the provided hardware. Follow the specific instructions in the manual for your pendant light model.
9. Once all connections are secure and the pendant shade is properly attached, restore power to the circuit by turning on the breaker.
10. Test the pendant light by turning on the switch. If the light does not turn on, double-check all connections and consult a licensed electrician if necessary.
Please note that these instructions are a general guide. It is always recommended to refer to the specific installation manual provided with the Dainolite PHA-241P-MB-500 Philomena Grey Transitional Cone Pendant Light for detailed and model-specific instructions.
Add New Comment