User Manual Q&AAnswer
Mar 21, 2025 - 04:54 AM
Installation of the RAB SMPFA1x1S20UNVTW Surface Panel can be done using either a J-Box or a bracket. Here are the steps for installation using a bracket, as outlined in the provided instructions:
1. Turn off/disconnect power at the circuit breaker.
2. Attach the connector provided to the AC cable from the junction box.
3. Attach the bracket to the junction box using the two short screws provided. Pull the AC cables through the bracket center hole.
4. Align the bracket to the desired position and angle. Mount four long screws provided in the ceiling through the bracket.
5. Select the desired CCT (Correlated Color Temperature). Slide the safety wire into the slot of the bracket. Rest the product on the safety wire while performing the electrical installation. Do not disconnect the safety wire after installation.
6. Make wire connections between the fixture and junction box using the wire nuts provided.
7. Lift the fixture up against the bracket and slide it to the locked sign to lock the fixture in place. Remove any labels.
Please note that these instructions are a summary, and it is important to refer to the complete instructions provided with the product for detailed and accurate installation guidance.
Add New Comment