Answer

Mar 21, 2025 - 04:32 AM
To install the KICHLER 49964AVI Mill Lane 1 Light Outdoor Hanging Pendant, please follow the steps below:
1. Before starting the installation, make sure to disconnect power at the main circuit breaker panel or main fusebox.
2. Thread the small threaded pipe into the end of the second loop. Pass the threaded pipe on the loop up through the hole in the canopy.
3. Thread the lockwasher onto the end of the threaded pipe protruding from inside the canopy.
4. Thread the hexnut onto the threaded pipe protruding from inside the canopy.
5. Attach one end of the chain to the loop on top of the roof. Attach the other end of the chain to the small loop on the canopy.
6. Weave the electrical wire and ground wire through the chain links, making sure they are no more than 3 inches apart.
7. Find the appropriate threaded holes on the mounting strap that align with the hole distance in the canopy. Thread the mounting screws into the threaded holes, starting from the outlet box side.
8. Attach the mounting strap to the outlet box with the strap mounting screws. The mounting strap can be adjusted to suit the position of the fixture.
9. Follow the grounding instructions provided in the manual. Depending on the type of fixture, either wrap the ground wire from the outlet box around the green ground xxxx and thread it into the hole on the mounting strap, or attach the ground wire from the outlet box under the cupped washer and green ground xxxx , and thread it into the mounting strap. If the fixture is provided with a ground wire, connect it to the outlet box ground wire using a wire connector. Never connect the ground wire to the black or white power supply wires.
10. Push the fixture to the ceiling, carefully passing the mounting screws through the holes in the canopy.
11. Thread the lock-up knobs onto the mounting screws and tighten them to secure the fixture to the ceiling.
12. Raise the glass up into the fixture, passing the smaller opening of the glass over the socket. Rest the top of the glass against the pads in the fixture roof.
13. Thread the socket ring onto the socket and tighten it to secure the glass in place. Be careful not to over-tighten.
14. Finally, insert the recommended bulb (not supplied) into the socket.
If you have any further questions or need assistance, you can contact KICHLER customer support at 866-558-5706, Monday to Friday, 9am to 5pm EST.
Add New Comment