User Manual Q&AAnswer
Mar 21, 2025 - 03:25 AM
To install the Dainolite PTO-201P-MB-BW Portobello 1 Light 20 Inch Pendant, please follow these steps:
1. Turn off the power: Before starting the installation, make sure to turn off the power to the circuit you will be working on. This can be done by switching off the circuit breaker or removing the fuse.
2. Mounting bracket: Attach the mounting bracket to the electrical box on the ceiling using the provided screws. Ensure that the bracket is securely fastened.
3. Wiring: Connect the wires from the pendant to the corresponding wires in the electrical box. Match the black wire from the pendant to the black (hot) wire in the box, the white wire from the pendant to the white (neutral) wire in the box, and the green or copper wire from the pendant to the green or bare copper wire in the box. Use wire connectors to secure the connections.
4. Hanging the pendant: Carefully lift the pendant and align the mounting screws on the pendant with the holes in the mounting bracket. Insert and tighten the screws to secure the pendant in place.
5. Adjusting the height: If desired, you can adjust the height of the pendant by adjusting the length of the chain or rod provided. Follow the instructions in the manual for adjusting the height.
6. Finishing touches: Once the pendant is securely installed, double-check all the connections and ensure that the pendant is level. Restore power to the circuit and test the pendant to ensure it is working properly.
Please note that these are general installation instructions. It is always recommended to refer to the specific instruction manual provided with the Dainolite PTO-201P-MB-BW Portobello 1 Light 20 Inch Pendant for detailed and accurate installation steps.
Add New Comment