Answer

Mar 21, 2025 - 02:27 AM
The Origin 21 42632 Golani LED Wall Sconce can be installed using either the plug-in or hardwire method. Here are the step-by-step instructions for both installation methods:
Plug-In Installation:
1. Turn off the circuit breakers and the wall switch to the supply line leads.
2. Determine the desired location for the fixture and mark the anchor locations on the wall. Drill holes and insert the anchors.
3. Set two screws into the anchors, leaving enough exposed to set into the keyhole slots on the preassembled wall plate.
4. Align the keyhole slots on the wall plate with the screws on the wall and slide the wall plate down until secure.
5. Install the LED bulb into the socket of the fixture.
6. Attach the glass globe to the fixture by twisting it firmly in a clockwise direction.
7. Turn on the electrical power at the main fuse or circuit breaker.
8. Insert the plug preassembled to the power cord into a nearby electrical outlet and move the switch on the underside of the fixture to the ON position.
Hardwire Installation:
1. Turn off the circuit breakers and the wall switch to the supply line leads.
2. Remove the wall plate from the back of the fixture by unscrewing and removing the two xxxx caps from the front of the fixture.
3. Use the two mounting bracket screws to attach the mounting bracket to the outlet box.
4. Loosen the ground xxxx on the mounting bracket and wrap the green/bare (ground) supply wire from the outlet box around the ground xxxx . Tighten the ground xxxx to secure the ground wire.
5. Remove the power cord from the fixture by releasing the wires from the wire connectors preassembled to the fixture wires. Pull the power cord through the grommet at the bottom of the fixture.
6. Insert the plug button through the grommet and secure it with the hex nut.
7. Make the following wire connections using the wire connectors preassembled to the fixture wires:
- Push the bare/green (ground) supply wire into the wire connector preassembled to the copper wire.
- Push the white (neutral) supply wire into the wire connector preassembled to the white wire.
- Push the black (hot) supply wire into the wire connector preassembled to the black wire from the switch.
8. Insert the two screws preassembled to the mounting bracket through the two holes in the fixture and secure with the two xxxx caps.
9. Install the LED bulb into the socket of the fixture.
10. Attach the glass globe to the fixture by twisting it firmly in a clockwise direction.
11. Turn on the electrical power at the main fuse or circuit breaker.
12. Move the switch on the underside of the fixture to the ON position.
Please refer to the instruction manual for any additional information or troubleshooting tips.
Add New Comment