Answer

Mar 20, 2025 - 11:29 PM
To authorize your Enelion LUMINA Electric Vehicle charger using an RFID card, please follow these steps:
1. Connect to the charger's hotspot using a network ID featuring "Enelion".
2. Enter the password from the sticker on the charger's head.
3. Open a web browser and type "192.168.8.8" into the address bar.
4. Log in to the configuration panel using the default credentials "admin/admin".
5. Place the RFID card against the top lid of the charger.
6. Navigate to the "Charger -> Authorization" section in the configuration panel.
7. In the "RFID Cards' History" section, locate your card.
8. Click on the "+" button to add the card to the "Offline Authorized Cards" group.
9. If you want to disable the Freecharge mode, make sure to do so in the configuration panel.
Please note that these steps are provided as a general guide and may vary slightly depending on the specific version or firmware of your Enelion LUMINA Electric Vehicle charger. For more detailed instructions and troubleshooting, refer to the user manual provided with your charger or visit the Enelion website at enelion.com/en/help.
It is important to follow the safety instructions mentioned in the manual and to contact an authorized service center for any maintenance, installation, or repair work to ensure proper functioning and safety of the charger.
Add New Comment