User Manual Q&AAnswer
Mar 20, 2025 - 11:04 PM
To pair the NUX B-10 Vlog Wireless Microphone System, follow these steps:
1. Turn on both the TX (transmitter) and RX (receiver) units by pushing and holding the power button for 2.5 seconds.
2. Before the units are paired automatically, you can check the battery status of the TX by observing the LED indicator. Green blinking indicates a well-charged battery, yellow blinking indicates medium battery, and red blinking indicates a lower battery. If the LED flashes red for 10 times, it means the battery is low and the unit will turn off automatically to protect the battery life.
3. After 2 seconds, the units will be paired automatically, and the TX's LED status will blink green. The RX's display will show ((e)) if it doesn't receive a signal, and it will show (()) to indicate the current receiving signal strength once it receives the signal.
4. Clip the TX as a lavalier microphone to your voice. You can also clip on the supplied windshield if required. If desired, you can plug in a compatible external microphone, and the TX will automatically switch to the audio input from the external microphone.
5. The TX has a mute function. While the B-10 is working, you can press the TX's power button once to enter mute status. The TX's LED will show red, and the RX's display will indicate mute status. Press the TX's power button again to go back to normal work status, and the TX's LED will show green.
6. To charge the wireless units, turn off both the TX and RX, and use the included USB-C Y-cable to charge them directly. The RX's display will show the current charging status. Make sure to use a power adaptor with a power output of 5V and 1A or higher.
7. If you want to use a different transmitter or receiver to pair with the B-10 Vlog, you can manually reset the ID match. Turn off both the TX and RX, then hold the power button of both units for more than 8 seconds. The TX's LED will show green when the ID match is finished, and the units will enter normal work status.
Note: The B-10 Vlog can be used simultaneously with up to 6 systems in one space. However, it is recommended to avoid using other wireless systems together with NUX ones to prevent noise or interference issues.
For more detailed information and instructions, please refer to the NUX B-10 Vlog Wireless Microphone System User Manual.
Add New Comment