Answer

Mar 20, 2025 - 10:50 PM
To load the SENCO SLP20XP 18 Gauge Brad Nailer, follow these steps:
1. Disconnect the air supply and make sure the tool is not connected to any power source.
2. Release the feeder shoe and slide it forward to open the magazine.
3. Insert a strip of 18 gauge brad nails into the magazine, making sure to use only genuine SENCO fasteners.
4. Close the magazine by sliding the feeder shoe back into place.
5. Reconnect the air supply and ensure that the tool is properly connected and ready for use.
Please refer to the instruction manual for more detailed information and illustrations on loading the brad nails into the SENCO SLP20XP 18 Gauge Brad Nailer.
Add New Comment