Answer

Mar 20, 2025 - 10:49 PM
To bleed the hydraulic system of the floor jack, follow these steps:
1. Loosen the Fill xxxx on the hydraulic unit.
2. Twist the Handle counterclockwise to open the Valve.
3. Check the fluid level and top off if necessary.
4. Twist the Handle clockwise to close the Valve.
5. Pump the Handle quickly several times.
6. Replace the Fill xxxx .
After bleeding the hydraulic system, it is important to test the jack for proper operation before using it. If the jack does not appear to be working properly even after bleeding, it should be repaired by a qualified service technician before use.
Add New Comment