User Manual Q&AAnswer
Mar 20, 2025 - 04:40 AM
To assemble and install the ET2 Contemporary Lighting E23307-20PC Zephyr LED Wall Sconce, please follow these steps:
1. Before getting started, carefully read the instructions provided with the product to familiarize yourself with the process.
2. Open the package using a sharp tool like a cutter knife, being careful not to damage the components inside.
3. Remove all packaging materials and retain them for future use.
4. Choose a clean, level, and spacious area for assembly. Avoid hard surfaces that may damage the product.
5. Ensure that you have all the required contents for complete assembly.
6. Assemble the product in close proximity to where you intend to position it, taking care when lifting.
7. Do not over tighten the screws and bolts as this may damage the threads.
8. Do not let children play with the product, and keep all hardware parts and packaging out of their reach.
9. For low voltage LED lighting instructions, carefully read through the instruction sheet before assembly and use. Disconnect from the power source before assembling or cleaning to avoid the risk of shock.
10. The wires need to be connected to the driver found in the canopy and should not be connected directly to the power source to prevent a short circuit.
11. Do not cut factory connections unless instructed by the manufacturer.
12. Do not plug the product in if the cord is torn or frayed.
13. For cleaning and maintenance, use talc powder on polished finishes to reduce the appearance of fingerprints and smudges. Use appropriate cleansers for respective shade surfaces such as glass cleaner, acrylic polish, and wood polish. Clean with a soft cloth and mild detergent, avoiding abrasive cleaners.
14. Periodically (every 90 days), ensure that all screws are fully tightened.
15. Avoid prolonged exposure to heat sources, as it may cause glazing, melting, scorching, or fading of colors.
Please note that the ET2 Contemporary Lighting E23307-20PC Zephyr LED Wall Sconce must be installed by a licensed electrician with knowledge of electronic lighting systems. Cutting factory connections without qualified knowledge will void the warranty.
Add New Comment