Answer

Mar 20, 2025 - 04:33 AM
To install the HINKLEY 1553BZ Taper 12v 1.9w 3 Inches Tall LED Step Light, follow these steps:
1. Use the provided mounting template to drill holes in the mounting surface. Place the template in the desired location for the fixture.
2. Use a 3/32" diameter drill to create pilot holes at the points indicated on the template.
3. xxxx #6 Phillips head wood screws into the pilot holes until the base of the xxxx head is 3/16" from the mounting surface.
4. If the wiring is going through the mounting surface, drill out the hole on the template as indicated.
5. For wiring the fixture, ensure that the input voltage is between 9-15 Volts AC. Connect one of the fixture wires to the live supply wire and the other to the neutral supply wire. If needed, splice the supply wires to connect them.
6. The luminaire is provided with two wire nuts and silicone glue to connect it to the supply wires from the transformer. Apply silicone glue to the inside of the wire nut before twisting it onto the wires.
7. The main low voltage cable from the transformer should be protected by routing it in close proximity to the luminaire or a building structure such as a house or deck. It should not be buried, except for a maximum of 6 inches, in order to connect to the main low voltage cable. Cut off the length of the cable so that it is connected to a connector within 6 inches from a building structure, luminaire, or fitting.
Please refer to the provided instruction manual for any additional information or specific details related to the installation process.
Add New Comment