Answer

Mar 20, 2025 - 02:02 AM
To install the COOKOLOGY CEI1100SS 10cm Ceiling Extractor Hood, follow these steps:
1. Before installation, turn off the unit and unplug it from the outlet.
2. Ensure that the ceiling can bear at least 120KGs weight and has a thickness of ≥30MM.
3. Drill 14pcs φ8mm holes on the ceiling according to the size shown in the manual.
4. Use 14pcs explode screws (or 14pcs ST6*40mm big flat screws + 14pcs wall plugs) to fix the two hanging boards on the ceiling.
5. Calculate the length of the angle iron and use 32pcs of M4*10 screws and M4 nut with gasket to connect the angle iron into the adjustable angle iron bracket.
6. Choose the direction of the outlet (①/②/③/④) as shown in the manual.
7. Open the decorative plate in order and take out the filter.
8. Unscrew and remove the 4 pcs ST4*8mm screws that are on the panel decorative strip.
9. Unscrew the 8pcs machine silk from the bottom of the cabinet housing and rotate it by 90°/180°/270° to choose the direction of the outlet. Then xxxx the 8 pcs machine silk to fix the housing well.
10. Install the panel decorative strip and filter in the reverse order of the steps above. Also, install the expansion pipe to the outlet.
11. Connect the 4 adjustable angle iron brackets with the housing using 8pcs M4*12mm machine silk screws.
12. Lift up the housing and use 8pcs M4*12mm machine silk screws and M4 nut with gasket to fix the housing onto the 2 hanging boards. Pull the expansion pipe outside and ensure it is firmly fixed on the housing.
13. After installing the housing to the hanging boards, use a screwdriver to adjust the xxxx of the angle iron bracket to level the housing position and height. Use the safety xxxx to secure it.
14. Ensure that the area is clean before installation to avoid suction of remaining bits of broken wood and dust.
15. Do not share the same air ventilation tube with other appliances such as gas tubes, warmer tubes, and hot wind tubes.
16. The bending of the ventilation tube should be ≥120°, parallel or above the start point, and connected to the external wall.
17. Make sure the extractor is level to avoid grease collection at one end.
Please note that these are general installation instructions. For more specific details and diagrams, refer to the COOKOLOGY CEI1100SS 10cm Ceiling Extractor Hood Instruction Manual.
Add New Comment